Hot Sale Liush Electric Power Tailgate Lift Remote Trunk Opener Boot Lifter Foot Sensor for Haval H6 III Facelift 2024-
Trading Properties
Basic Properties
Mr. Wong
- +86 190 6808 0629 Contact Us
| Push Force: | 620 N Per Strut | Travel Time: | About 8 Seconds |
| System Voltage: | 12V DC Negative Ground | Temperature Range: | -25 To +75 Celsius |
| Bracket Finish: | Zinc Nickel Plated Steel | Foot Sensor: | IP67, Adjustable Range |
| Protection: | Anti Pinch Reverse, Current Limit, Inline Fuse | Cycle Test: | 45000 Open And Close Cycles |
| Actuator Set: | Pair Of Motorised Lift Struts | Module: | Solid State, Reads Gear And Vehicle Speed Signal |
| High Light: | Haval H6 III Facelift power liftgate,OEM supported tailgate conversion kit,Hands-free automatic boot opening system |
||
The facelift version of the Haval H6 III, sold from 2024 onwards, still ships with a hand operated rear door on most trim levels. This conversion package gives that door the behaviour of a premium SUV: the original gas struts are swapped for motorised ones, an electronic module takes over the travel, and the door can be commanded from the key fob, a dash mounted switch, the handle, or a foot sensor fitted behind the bumper. Fitment follows the factory bolt pattern, so the body is left untouched and the car can be returned to stock condition if needed.
Because the 2024- body uses a revised hinge geometry, the bracket set in this kit is specific to the facelift shell rather than shared with earlier cars. That detail keeps panel alignment tight and prevents the strut from binding at the top of the stroke.
- A Hall sensor tracks strut load and reverses the door the moment an obstacle is detected.
- The module only permits powered movement when the transmission is in P, so the door cannot open while the car is rolling.
- Current limiting protects the motor if the door is held or blocked for a long period.
- An inline fuse isolates the circuit in the event of a short, leaving the factory wiring intact.
| Item | Specification |
|---|---|
| Vehicle | Haval H6 III Facelift, 2024 onwards, rear tailgate |
| Actuator set | Pair of motorised lift struts |
| Push force | 620 N per strut |
| Supply | 12V DC, negative ground |
| Full travel time | Approx. 8 seconds |
| Sensor | Foot sweep sensor, IP67, range adjustable |
| Module | Solid state, reads gear and vehicle speed signal |
| Protection | Anti pinch, current limit, inline fuse |
| Bracket | Zinc nickel plated steel |
| Temperature | -25°C to +75°C |
| Cycle test | 45,000 open and close cycles |
| Warranty | 24 months |
- Support the tailgate, then unbolt and remove both original gas struts.
- Install the facelift specific brackets and mount the motorised struts on the ball studs.
- Run the plug in harness along the factory loom and connect the control module.
- Attach the foot sensor behind the rear bumper and set the detection distance.
- Store the opening height limit, then cycle the door twice and check the anti pinch stop.
Printed wiring diagrams and a photo guide ship with every kit, and installers can request a video walkthrough for their first unit.
Struts are held in a moulded foam insert inside a printed carton, and every fastener bag is labelled with its mounting position. Each set is bench tested before dispatch for motor current, harness continuity, sensor response and anti pinch reversal. Neutral packing, buyer branding, custom part numbers and translated manuals are available for distributors, and replacement struts, sensors and modules are stocked for fast after sales service.
Send the model year or VIN and we will confirm the correct variant, wholesale price and shipment schedule within one working day.