Retrofit Auto Power Tailgate Electric Trunk Lift Kit OEM Supported Kick Sensor for GAC Trumpchi E9 EV MPV
Trading Properties
Basic Properties
Mr. Wong
- +86 190 6808 0629 Contact Us
| Model: | GAC Trumpchi E9 EV MPV | OEM/ODM: | Support From 10 Sets |
| Actuator Force: | 700 N Per Side | Stroke: | 410 Mm |
| Door Mass Supported: | Up To 55 Kg | Power: | 12V DC, 20A Fused Isolated Tap |
| Standby Current: | Below 2 MA | Water Protection: | IPX5 |
| Cycle Test: | 40,000 Operations | Warranty: | 24 Months |
| High Light: | Electric Car Trunk Lift,Automatic Trunk Opener,Auto Tailgate Kit |
||
Electric Trunk Lift Kit for the GAC Trumpchi E9 EV
The E9 is a large electric MPV with a tall, heavy rear door and a cabin that is used by families, chauffeurs and shuttle operators. This kit gives that door motor drive: opening from the key, closing from the key, with a soft latch pull at the end of every cycle.
Built for an Electric MPV
EV wiring is less forgiving than a combustion car, so the kit takes its supply through a fused tap that does not interfere with the high-voltage system or the vehicle's 12V management. Standby draw is kept below 2 mA, which matters on an EV that may sit unused for days between charges. Actuators are rated 700 N per side to handle the E9's wide, glass-heavy tailgate.
Feature Set
| Feature | Detail |
|---|---|
| Open / close | Key button, cabin switch and tailgate handle |
| Kick sensor | Optional foot sweep bar for hands-free opening |
| Soft latch | Damped final pull protects the latch and seals |
| Obstacle reverse | Hall feedback plus current monitoring |
| Height memory | One stored opening point |
| Park interlock | Only operates in P position |
Specifications
- Vehicle: GAC Trumpchi E9 (EV / PHEV MPV)
- Actuator force: 700 N per side
- Stroke: 410 mm
- Door mass supported: up to 55 kg
- Power: 12V DC, 20A fused, isolated tap
- Standby current: below 2 mA
- Open / close time: 8 s / 7 s
- Water protection: IPX5 | Noise: under 58 dB
- Cycle test: 40,000 operations
- Warranty: 24 months
Installation
Brackets mount on the factory hinge points, the harness follows the existing tailgate loom through the original grommet, and the module sits behind the rear quarter trim away from the battery pack service area. Workshop time is around two and a half hours. No cutting, welding or paint work is required.
Packing
One set per carton, 92 x 28 x 25 cm, sized for the longer E9 actuators. Struts are sleeved in EPE, brackets bagged by side, hardware counted into numbered bags, and two cartons fit a master carton. Pallet loading and buyer carton marking are available.